DIY perspex clutch7.8.12
You'll need :
Put two sheets of perspex together and using a thick needle make tiny holes on 3 sides. Remember to leave one side holes-free.
Thread the thin needle and go through the holes .
You should end up with something envelope look alike.
If you like basic, minimal look you can leave 3rd sheet as it is, or cut the edges to give it a nicer shape as this going to be the flap of your clutch. Outline the edges of the flat, just like you did it in step 2.
Attach the flap to the back of your envelope.
Addspressbutton in the front. Et voila ! :)
Hope you enjoyed this tutorial, make sure to comment and share.